immer-mobil TCN 8200 Mode D'emploi page 100

AVOID ANY PHYSICAL DAMAGE
Before carrying out maintenance
on the machine:
1. Put the machine in a stable con-
figuration with the horizontal axis
completely retracted and the pole
8.1. PRELIMINARY CHECKS
Check that there is a pressure of at least 8 bar on the filter regulator pressure gauge.
If the pressure is below the minimum level, some machine operations may be limited
or insufficient.
After the correct pressure has been restored, the machine will operate properly.
Check that the machine has been adequately connected to the electric mains and the
pneumatic supply.
8.2. DECIDING FROM WHICH SIDE OF THE WHEEL THE TYRE
MUST BE REMOVED
See Fig.13. Identify the position of channel A on the
rims. Identify the greater width B and the smaller width
C. The tyre must be mounted and demounted with
the wheel on the turntable with the smallest width
side C facing upwards.
SPECIAL WHEELS
Wheels with alloy rims: some wheels with alloy rims
have a minimum A rim channel or do not have any channel - Fig. 13A. These rims are not
approved by DOT standards (Department of Transportation). The DOT initials certify that
100
CAUTION
in working or resting position (Fig. 12c).
2. Disconnect the power supply plug (Fig 12a).
3. Isolate the compressed air line by dis-
connecting the closing valve (quick release
connector) (Fig. 12b.)
12c
12a
Operator manual
12b
C
A
B
13