immer-mobil TCN 8200 Mode D'emploi page 113

- Press the pedal
- Remove the wheel from the tyre changer.
8.8.c. SPECIAL PROCEDURE (TI VERSION)
The TI version facilitates bead insertion and inflation of Tubeless tyres through the
emission of a strong jet of air from the nozzles placed near the locking wedges.
Before starting with the operations described below, make sure there is no dirt, dust
or other impurities near the inflation nozzles. It is advisable to wear protective goggles.
- Verify that both upper and lower tyre beads and rim bead seat have been properly lubricated
with an approved mounting paste.
- Move the horizontal arm to the wheel centre (all
slipped off towards the operator)
- Make sure that the wheel is secured to the turntable
from the inner side (fig. 34).
- Lower the vertical arm until it touches the rim (fig.31),
then clamp the arm in this position.
- Remove the valve core if it has not already been removed (Fig. 32).
- Connect the Doyfe connector of the inflating hose to the valve stem (Fig. 33).
To increase the effectiveness of the air jets, manually lubricate and lift the lower
bead before activating the nozzles.
- Fully press the inflation pedal for a short
time (Fig. 35). The tyre will expand, and the
beads will seat.
Operator manual
to move the column into the "non-working position".
CAUTION
CAUTION
34
UK
35
113