immer-mobil TCN 8200 Mode D'emploi page 105

• Turn the adjustment device using the knob until securing it into the new position (A
Fig. 18d).
• Check that the locking pin is firmly secured in its housing.
The setting of the diameter range (10"→20" or 14"→24" for TCN 8240 - 10"→22"
or 14"→26" for TCN 8260), using the adjustment device, must be carried out with
the turntable completely stopped without acting on the controls.
- Turntable jaws are opened and closed by sequentially pressing the control pedal
.
- With the jaws completely closed, lightly press the
control pedal
position (Fig. 19a).
In this configuration, it is possible to carry out dead-
man control of jaws opening and then stop them in
the desired position.
- If the rim is blocked from the outside (Fig. 19b),
pre-position the locking wedges using the references
of the diameters shown on the turntable and the red
notch on the jaw (Fig. 19c).
E.g.: Rim 18", pre-position the jaws making the red
notch match with value 18".
- If the rim is blocked from the inside (Fig. 19d), it is
not necessary to pre-position the locking wedges. The
very shape of the wedge brings the rim to be locked
into the correct position.
- Place the wheel (with the narrow shoulder of the
rim facing up) on the turntable,
- Push it slightly downwards and operate the control
pedal to lock the wheel in position (fig.20).
Operator manual
CAUTION
and move it to the central
19A
19b
19c
UK
19d
105