immer-mobil TCN 8200 Mode D'emploi page 114

To improve the operation of the tubeless tyre inflation system the line pressure must
be between 8 and 10 bar.
- Unlock the wheel from the wedges.
- Move the inflation pedal into an
intermediate position (Fig. 36) to inflate
the tyre. Frequently check that the pressure
NEVER exceeds the maximum pressure
indicated by the manufacturer on the tyre.
Risk of explosion. During the bead insertion phase, do not exceed the maximum pres-
sure indicated by the manufacturer
Operate the inflation jets only for tyre bead insertion.
Discharge the air from the pneumatic system before disconnecting the power supply or
other pneumatic components. The air is accumulated in the tank for operating the bead
insertion jets.
Operate the air jets only after making sure that the rim is correctly blocked.
RISK OF EXPLOSION. Do not mount a tyre and a rim that do not have the same diameter
(e.g., 16 and 1/2 inch tyre and a 16 inch rim).
If the tyre is excessively inflated, the air can be released
by pressing the brass manual deflation button located
below the air pressure gauge (2 - Fig.37)
- Disconnect inflation hose from valve rod.
114
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
1
2
Operator manual
36
37