immer-mobil TCN 8200 Mode D'emploi page 109

- Place the tyre on the rim and tilt the
pole into the working position
. Position the lower bead (fig.27) beneath
the right hand side of the tool head.
Press the turntable control pedal
to turn the bead clockwise and mount it.
Use the rim channel by pressing on the right
wall of the tyre to reduce traction force on
the bead as the wheel rotates (fig.27).
- Once you have mounted the first bead,
repeat the same steps for the second bead
(fig.28).
- Press the pedal
column into the "non-working position".
- release the wheel and remove it from the
tyre changer.
Special tools
To make it easier to mount/demount low profile tyres, it is advised to use the bead presser
gripper (optional accessory supplied on request).
Operator manual
26
to move the
27
28
UK
109