immer-mobil TCN 8200 Mode D'emploi page 127

Bead pressing tool. A tool intended for use when
mounting the top bead. It is positioned so that it engages
the shoulder of the rim and maintains the upper tyre
bead inside the well. It is generally used for mounting
low profile tyres.
Discharge regulator. Union allowing regulation of the
air flow.
Bead breaking. Operation used to detach the bead from
the rim edge.
16. GENERAL WIRING
DIAGRAM
Fig. 40a-b-c-d
XS1 Power supply socket
X1 Power supply plug
QS1 Inverter
S2 Two-speed inverter
M1 Single-phase motor
M3 Three-phase motor
R1 Resistor
C1 Capacitor
Fr Fuse
AP1 Single/two-speed motor circuit board
SQ1 Two-speed microswitch
SQ2 Microswitch (clockwise rotation)
SQ3 Microswitch (anticlockwise rotation)
Operator manual
c
a
b
UK
127