immer-mobil TCN 8200 Mode D'emploi page 112

A bursting tyre can cause projections of its parts in surrounding areas with a force
sufficient to cause serious injury or death.
Do not mount a tyre if its dimensions (indicated on the side) do not correspond
exactly to the rim dimensions (printed inside the rim) or if the rim or the tyre is
defective or damaged.
Never exceed the pressure recommended by the tyre manufacturer.
The tyre changer is not a safety device and does not prevent tyres and rims from
exploding. Keep all persons not working on the machine out of the working area.
8.8.b. TYRE INFLATION
-Make sure the wheel is NOT
clamped on the turntable by the
centring jaws (Fig. 30).
- Move the horizontal arm to the
wheel centre (all slipped off towards
the operator)
- Lower the vertical arm until it
touches the rim (fig.31), then clamp the
arm in this position.
- Remove the valve core if it has not already
been removed (Fig. 32).
- Connect the Doyfe connector of the
inflating hose to the valve stem (Fig. 33).
- Inflate the tyre with the suitable gun or
by pressing the pedal in the intermediate
position, frequently checking the pressure
on the pressure gauge to make sure
that it NEVER exceeds the maximum
pressure indicated by the
manufacturer of the tyre.
- Disconnect inflation
hose from valve rod.
112
DANGER
YES
32
NO
30
31
33
Operator manual