immer-mobil TCN 8200 Mode D'emploi page 107

- Insert and position the bead lifting lever
on the mounting tool head (fig.23).
When working with alloy rims or rims
with delicate paintwork, you are advised
to remove the bead lifting tool before
proceeding with the demounting.
Grip the bead lifting tool firmly during use.
- Lift the upper bead above the rear part
of the demounting tool head (fig.24) and
push one part of the upper bead into the
rim channel by pushing downwards on the
side wall of the tyre near the operator.
- Press the turntable drive pedal
making the wheel turn clockwise. The upper
bead will be automatically guided up over
the rim edge (fig.25).
- Repeat the last three points to detach the
lower bead.
Operator manual
CAUTION
24
,
23
UK
25
107