immer-mobil TCN 8200 Mode D'emploi page 101

tyres comply with the safety standards adopted by
the United States and Canada (these wheels cannot
be sold in these markets).
High performance wheels (asymmetric curvature) -
Fig. 13B some European wheels have rims with very
pronounced curvature C, except in the area of the
valve hole A where the curvature is less pronounced
B. On these wheels the bead must first be broken in
correspondence of the valve hole, on both the top
and bottom sides.
Wheels with pressure sensor - Fig.13C. To work
correctly on these wheels and avoid damaging the
sensor (which can be incorporated in the valve,
secured to the belt, glued inside the tyre, etc.) suitable
mounting/demounting procedures must be observed
(refer to "Approved mounting/demounting procedure
for runflat and UHP tyres").
The TPMS device (optional accessory) can be used to check the proper operation
of pressure sensor.
Remove the old weights from the rim before starting work operations.
8.3. BEAD BREAKING
Before bead breaking operation, completely close the turntable (locking wedges towards
the centre) (A, Fig.16), keeping your hands away from moving parts.
- Fully deflate the tyre by removing the valve (fig. 14a).
Operator manual
CAUTION
CAUTION
CAUTION
A
A
B
A
13a
C
13b
B
C
13c
UK
101