immer-mobil TCN 8200 Mode D'emploi page 90

Handling
To move the package insert the forks of a forklift
truck into the specific slots on the base of the
package itself (pallet) (Fig. 3).
Before moving the machine, refer to the LIFTING/
HANDLING section.
Keep the packing material intact for possible future transport of the machine.
3. UNPACKING / ASSEMBLY
Pay careful attention when unpacking, assembling, handling and installing the ma-
chine as described below. Failure to observe these instructions could damage the
machine and compromise operator safety.
Before removing the machine from the pallet, make sure the items shown below have
been removed.
Remove the upper part of the package
and make sure that the machine has not
suffered damage during transport; identify
the points for fastening to the pallet.
- The machine consists of five main units
(fig.4):
1 head
2 air tank (FI version only)
3 box with pressure gauge (FI version
only)
4 pole guard
5 body
- After removing the head 1, it is advisable
to place it in a horizontal position
to prevent it from falling and getting
damaged.
90
CAUTION
CAUTION
CAUTION
3 4
2
5
3
1
4
Operator manual