immer-mobil TCN 8200 Mode D'emploi page 87

1.3. ADDITIONAL RIM/TYRE INFORMATION
Wheels equipped with pressure sensors and special rims or tyres could require
particular work procedures. Consult wheels and tyre manufacturer's service
manuals.
1.4. INTENDED MACHINE USE
This machine must only be used to demount and mount vehicle tyres from/on the rims, using
the provided tools. Any other use is improper and may result in injury.
1.5. PERSONNEL TRAINING
1. Employers are responsible for providing a training program for all employees who work on
the wheels concerning the hazards deriving from maintenance and the safety procedures
to be observed. Service or maintenance refer to mounting and demounting wheels and all
the correlated activities, such as inflation, deflation, installation, removal and handling.
• Employers are required to make sure that operators do not work on the wheels unless they
have received suitable training regarding the correct maintenance procedures for the type
of wheel being serviced and the operative safety procedures.
• Information to be used for the training program includes, as a minimum, the information
contained in this manual.
Operator manual
DANGER
• RISK OF EXPLOSION
• Never exceed tyre pressure recommended by
tyre manufacturer.
• Always match the tyre and rim dimensions.
• Take care to avoid any damage to the tyre.
• During inflation, keep outside the vertical
cylinder area occupied by the wheel.
CAUTION
UK
87