immer-mobil TCN 8200 Mode D'emploi page 102

- Adjust the bead breaker shoe opening
by turning the screw located on
the cylinder rod (fig.15, TCN 8200
excluded).
- Position the wheel as shown in fig.16 and move the bead breaker shoe near the rim edge.
- Press the pedal B (fig.16) to operate the bead breaker and detach the bead from the rim.
Repeat this operation on the other side of the wheel.
It may be necessary to break the bead at several points to free it completely. After
detaching the beads, remove the old balancing weights.
8.4. CLAMPING THE WHEEL
Keep your hands and other body parts away from moving parts of the machine while moving
the wheel locking wedges.
102
14a
CAUTION
B
15
A
16
Operator manual