immer-mobil TCN 8200 Mode D'emploi page 91

- Remove the side cover.
- Insert the air hose (G fig.5) into hole (A fig. 5) behind the pole tilting cylinder.
- Assemble head (1 fig. 5), insert pin (B fig. 5) into hole (C fig. 5) and lock it with the screw
and washer (D fig. 5).
- Insert pin (E fig. 5) into hole (F fig. 5) and in the U-bolt (F1 fig. 5) of the pole tilting
cylinder and lock it with ring (M fig. 5).
- Connect hose (G fig. 5) to the intermediate union connected to the pole lifting valve (H
fig. 5).
- Assemble the box with pressure gauge (3 fig. 5) on pole (1 fig. 5) and lock it with the
screw and washer (S fig. 5).
- Fit the pole guard (2 fig. 5) and lock it with screws and washers (L fig. 5).
- Insert the tank union (4 fig. 5) into hose (Q fig. 5), secure tank (4 fig. 5) to the machine
using nuts and washers (R fig. 5) and tighten the clamp (O fig. 5) on hose (Q fig. 5) (FI
version only).
G
H
Operator manual
3
1
S
2
M
E
F
D
F1
L
G
A
C
B
R
4
O
Q
5
91
UK