immer-mobil TCN 8200 Mode D'emploi page 108

- Tilt the pole backwards.
NOTES: If the tyre has an inner tube, after detaching the upper bead, tilt the pole
backwards and remove the inner tube before proceeding to demount the lower bead.
The rotation of the turntable can be stopped at any time by releasing the pedal.
To rotate in the opposite direction, simply raise up the pedal.
- Lift the second bead manually on the head, then rotate the turntable clockwise until
the tyre has been completely demounted from the rim.
- Press the pedal
If the tyre has an inner tube, after demounting the upper bead, tilt the column back
and remove the inner tube before proceeding to demount the lower bead. Turntable
rotation can be stopped at any moment by releasing the drive pedal.
To rotate in the opposite direction, simply raise up the pedal.
8.6. WHEEL MOUNTING
RISK OF EXPLOSION. Always check that the tyre/rim combination is correct in terms
of compatibility (tubeless tyre on tubeless rim, tyre type with inner tube on rim for
inner tube) and geometric dimension (shrinkage diameter, width cross section, off-
set and shoulder profile) before mounting.
AVOID THE RISK OF PERSONAL INJURIES OR DEATH.
Also check that the rims are not deformed, that their fastening holes have not
become oval, that they are not encrusted or rusted and that they have no sharp
burrs on the valve holes.
Check that the tyre is in good condition with no signs of damage.
- Before you start with tyre mounting operations, lubricate the beads (fig.26).
Lubricated beads require less force to mount and are protected against damage.
- Check that the tyre is in good condition with no signs of damage.
108
to move the column into the "non-working position".
CAUTION
DANGER
Operator manual