Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Safety Limits
In addition to the standard safety controls,
such as the high pressure cutout, your
ice machine features built-in safety
limits which will stop the ice machine if
conditions arise which could cause a major
component failure.
Before calling for service, re-start the ice
machine using the following procedure:
1.
Move the ICE/OFF/CLEAN switch to
OFF and then back to ICE.
A. If a safety limit has stopped the
ice machine, it will restart after a
short delay. Proceed to step 2.
B. If the ice machine does not
restart, see "Ice machine Does Not
Operate" on (See page 41).
44
2.
Allow the ice machine to run to
determine if the condition repeats.
A. If the ice machine stops again, the
condition has repeated. Call for
service.
B. If the ice machine continues to
run, the condition has corrected
itself. Allow the ice machine to
continue running.
Part Number 000017556 Rev 00 9/22
Section 5
Publicité
