Manitowoc S3000 Mode D'emploi page 34

Maintenance
Detailed De-scaling & Sanitizing
Procedures
Ice Machine De-scaler is used to remove
lime scale and mineral deposits. Ice
Machine Sanitizer disinfects and removes
algae and slime.
• The ice machine must be taken apart for
detailed se-scaling and sanitizing.
• Ice machines that are heavily scaled or
have not been cleaned on a regular basis
will need to run this procedure.
,
Use only Manitowoc approved Ice
Machine De-scaler and Sanitizer for this
application (Manitowoc De-scaler part
number 9405463 and Manitowoc Sanitizer
part number 9405653). It is a violation of
Federal law to use these solutions in a
manner inconsistent with their labeling.
Read and understand all labels printed on
bottles before use.
,
Do not mix De-scaler and Sanitizer
solutions together. It is a violation of
Federal law to use these solutions in a
manner inconsistent with their labeling.
n
Wear rubber gloves and safety goggles
(and/or face shield) when handling Ice
Machine De-scaler or Sanitizer.
34
Caution
Caution
Warning
Detailed De-scaling Procedure
Step 1 Set the toggle switch to the OFF
position after ice falls from the evaporator
at the end of a Harvest cycle. Or, set the
switch to the OFF position and allow the ice
to melt off the evaporator.
Step 2
Remove top cover. This will allow
easiest access for adding De-scaler and
Sanitizer.
Remove all ice from the bin/dispenser.


Notice
Never use anything to force ice from the
evaporator. Damage may result.
Step 3 Place the toggle switch in the
CLEAN position. The water will flow
through the water dump valve and down
the drain. Wait until the water trough refills
and water flows over the evaporator, then
add the proper amount of ice machine
de-scaler.
Amount of De-scaler
(#9405463)
16 oz (475 ml)
Step 4
Wait until the clean cycle is
complete (approximately 80 minutes). Then
place the toggle switch in the OFF position
and disconnect power to the ice machine.
n
Disconnect the electric power to the ice
machine at the electric service switch box.
Step 5 Remove parts for cleaning.
Please refer to Parts Removal. Continue
with Step 7 when the parts have been
removed.
Part Number 000017556 Rev 00 9/22
Section 4
Warning