Publicité
Les langues disponibles
Les langues disponibles
•
"Alarm! Close windows"
Is displayed instead of date and time, if a connected motion sensor was
activated. If no other signal is received from the motion detector within the
next 5 minutes, the display will disappear and the control will switch into its
normal automatic mode again.
•
"Weather station error! Only manual operation possible"
If this message is displayed, the control does not receive any data from the
weather station. Check the connecting line to the weather station and, if
necessary, have it inspected. Manual operation of the connected
components is still possible.
•
„Sensor error! Only manual operation possible"
If this message is displayed, the indoor temperature and humidity sensor is
defect.
If you re-start the control (keep ok key pressed and press menu for some
seconds) and you do not have installed an external sensor (WGTH), "indoor
temp. error" and/or "hygrometer error" will be displayed. Please have the
sensor checked.
If you have an external indoor sensor (WGTH) installed, "attempt 1 T1" will
be displayed in the bottom display line (date and time) every few seconds.
Please check the connecting line to the WGTH and have it checked, if
necessary. Re-start the control (keep ok key pressed and press menu for
some seconds), in order to use the internal sensor for indoor temperature
and humidity in the meantime.
•
If the connection between the control and an already configured WGBL
(ventilation module) has been interrupted, "Attempt 1 L(number from 1 to
8)" will be displayed in the bottom display line (date and time) every few
seconds. Have the relevant WGBL (1 to 8) checked.
Manual Operation
The WS1 is always fitted with keys for four channels. Depending on the
version, only the keys for channel 1 (WS1-1) or for channel 1 and 2
(WS1-2) or for channel 1, 2 and 3 (WS1-3) or all keys (WS1-4) are fully
functional!
78
Publicité
