Publicité
Les langues disponibles
Les langues disponibles
To remove it, the weather station can be simply pulled upwards out of the
mount, against the resistance of the fastening.
Notes on installation
Do not open the weather station if water (rain) could get in: even a few drops
could damage the electronics inside.
When mounting, you must take care not to damage the temperature sensor
(small PCB on the bottom of the housing). Also, the wire connecting the PCB
with the rain sensor must not be pulled off or kinked at the terminal.
Remove all existing protection labels after installation.
It will take 60 seconds after applying the power before the wind measurement
will be output.
102
Make sure the cover and bottom part are
properly snapped together! This picture is
looking at the closed weather station from
underneath.
Push the housing from above into the
fastened mount. The bumps on the mount
must snap into the rails in the housing.
Publicité
