Publicité
Les langues disponibles
Les langues disponibles
Use the + and – keys for adjustment and ok for change of position. Confirm
your adjustments with ok.
With the menu key you may return to the starting position of the control.
Settings on delivery/serial number/delete code
These functions may only be accessed with different numerical codes. With code
1 ("81"), the control may be reset to its default setting. With code 2, the serial
number may be changed. Resetting all data deletes all values that have been
entered so far, and may therefore lead to damage if applied inappropriately. The
language in the display is set to "German" by the reset to the default setting. If
you require one of the functions, please contact your dealer or Elsner Elektronik.
Also the access code (see next chapter) may be deleted, which serves to unblock
the control in case of emergency (f. ex. if the set access code has been
forgotten).
•
For deletion of the access code, please confirm the requests for the codes
for default settings and serial number with ok and ignore the following
error messages.
•
The request for deletion of the access code must also be confirmed with
ok. Code 3, which must now be entered, is "123". Keep pressing the + key
until the code has counted from 100 to 123, and confirm with ok.
With the menu key you may return to the starting position of the control.
Access code
The adjustment range for the automatic system of WS1 may be protected
against unauthorised adjustment with a numerical code. The control is supplied
with an unprotected adjustment range, the code number is then 0000. If in the
following a code number other than 0000 is entered, the numerical code will be
requested before every call of the setting menus. Manual operation of the
outputs with the external manual key and with the arrow keys on the control
panel is still possible, all other functions are blocked.
If you would like to set an access code, please proceed as follows:
•
In the starting position of the control, keep the ok key pressed and
additionally press the menu key for 2 seconds.
The display will show: "Change basic settings of output channels?".
117
Publicité
