Piccolo Xpress Manuel De L'opérateur page 106

2. Type a descriptive name (such as Abaxis) for the connection,
then click
OK
3. Use the Connect using menu to select the port that the analyzer is
connected to, which you recorded previously (see
then click
OK
Note: If the port is unknown, select any port. If needed, you can run
the wizard again to try other ports.
4. In the port's Properties dialog, change Bits per second to
then click
OK
5. If a valid port was selected, a new
HyperTerminal session will start.
The status pane on the lower left cor-
ner of the window should display
Connected as shown.
Note: If an error message appears, close HyperTerminal without saving changes. Run the
HyperTerminal setup wizard again, and choose a different port.
6. Click
File > Save As
sion file is saved so that it can be loaded in the future (create a shortcut on the desktop if nec-
essary). Proceed to the next section for instructions on capturing results.
10-10
.
. The other settings are not required.
.
on the menu to save the HyperTerminal session. Note where the ses-
Connecting a Computer/Printer
page 10-7),
,
9600