Piccolo Xpress Manuel De L'opérateur page 105

7. Select
Network Port Configurations
the Show list.
8. Check the
click
Apply Now
9. As needed, configure the computer's applications to communicate with the analyzer using
the new virtual communication port.
10.5 Capturing Results with HyperTerminal
10.5.1 Setting Up HyperTerminal
This section describes how to set up and use Windows HyperTerminal to capture and transmit analyzer
test results.
Note: The screen captures and menu configurations shown here may vary depending on your
version of Windows.
1. From the Windows desktop, click
Start > Programs > Accessories >
Communications > HyperTerminal
HyperTrm.exe
minal setup wizard.
Note: If HyperTerminal is not present,
install it by going to
Settings > Control Panel > Add/Remove Programs (Add/Remove Windows
Components > Communications
box for the new port, then
On
.
to start the HyperTer-
Start >
Connecting a Computer/Printer
from
>
tab). Consult Windows help for details.
10-9