General Maintenance - GreenWorks Tools 27017 Manuel D'utilisation

Motoculteur électrique
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
EN
FR
DE
ES
IT
PT

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake liquids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
Only the parts shown on the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced at an Authorized Service Center.
STORING THE CULTIVATOR
The following steps should be taken before storing the
cultivator for the season.
Clean dirt, grass, and other materials from the entire
unit.
Wipe the tines with oil or spray them with silicone
PROBLEM
Motor fails to start when switch
trigger is depressed.
Motor runs but tines do not move.
NL
SV
DA NO
FI
HU CS RU
English(Original Instruction)
lubricant to prevent rusting.
Oil the switch trigger cable and all visible moving parts.
Do not remove the motor cover.
Order new parts to replace any that are badly worn or
broken.
Store in an upright position in a clean, dry place. Store
with the handles in the extended position, or loosen
handle knobs and fold handles down. Do not allow
switch trigger cable to become pinched when lowering
the handlebar.
Store in a dry and clean place and out of reach of
children.
TROUBLESHOOTING
CAUSE
Power cord is not plugged in or
connection is loose.
Household circuit breaker is tripped.
Stone or root could become lodged
in the tines.
Tall grass or weeds may become
wrapped around the tine shaft.
Gear train failure.
20
RO PL
SL
HR ET
LT
REMEDY
Plug in the power cord.
Check circuit breaker
To clear the tines, release the trigger
lever. Unplug the tiller, and dislodge or
remove any obstacles from the tines or
tine shaft.
To ease removal of tall grass or weeds
that are wrapped around the tine shaft,
remove one or more of the tines from
the tine shaft. See Tine Removal and
Installation in the manual.
Take unit to authorized service center.
LV
SK BG

Publicité

Table des Matières
loading

Table des Matières