Assembling The Handle Bar - GreenWorks Tools 27017 Manuel D'utilisation

EN
FR DE ES IT PT
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
If any parts are damaged or missing, please call
customer service for assistance.
WARNING:
If any parts are damaged or missing do not
operate this tool until the parts are replaced.
Failure to heed this warning could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create
accessories not recommended for use with this
tool. Any such alteration or modifi cation is misus
and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly
is complete. Failure to comply could result in
accidental starting and possible serious personal
injury.

ASSEMBLING THE HANDLE BAR

See Figure 1
Align the holes on the upper handle with the holes on
the lower handle. Insert the bolts, and tighten them
using the wing nuts provided.
NOTE: Do not use force. If there is binding, continue
to loosen the knobs. Do not allow the switch cable to
become pinched when raising the handlebar.
ASSEMBLING THE WHEELS
See Figure 5
Disconnect from power source.
The wheels are used to control the depth of operation.
To adjust the height of the wheels.
Place cultivator in a stable position and transport as
shown.
Insert the wheel assembly into the support rod .
NL SV DA NO FI HU CS RU
English(Original Instruction)
INSTALLING THE TINES
See Figure
The cultivator has four tines —two inner tines stamped B
and C, and two outer tines stamped A and D. For correct
operation of the unit, the tines must be installed in the
correct orientation.
NOTE: Disconnect from power source. Lean the unit back
on its wheels so that the handlebar rests on the ground.
OPERATION
Place tine C on the tine shaft to the left of the gear box.
The stamped side of the tine should face away from the
e
gear box.
Place tine B on the tine shaft to the right of the gear box.
The stamped side of the tine should face away from the
gear box.
Place a felt washer on each side of the tine shaft, and
slide to rest against the inner tines.
Place the outer tine stamped D on the left side of the
tine shaft. The stamped side should face in toward tine
C.
Place the outer tine stamped A on the right side of the
tine shaft. The stamped side should face in toward tine
B.
17
RO PL SL HR ET LT LV SK BG