GreenWorks Tools 27017 Manuel D'utilisation page 19

EN
FR DE ES IT PT
WARNING:
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly and
understand completely the operator's manual.
If you do not understand the warnings and
instructions in the operator's manual, do not use
this product. Call
assistance.
WARNING:
The operation of any cultivator can result in
foreign objects being thrown into your eyes,
which can result in severe eye damage. Before
beginning cultivator operation, always wear safety
goggles or safety glasses with side shields and,
when needed, a full face shield. We recommend
Wide Vision Safety Mask for use over eyeglasses
or standard safety glasses with side shields.
SAVE THESE INSTRUCTIONS
ELECTRICAL
ELECTRICAL SAFETY
The mains voltage must correspond to the one marked on the
technical data plate (220-20V~50Hz). Do not use other sources
of power.
The use of a safety circuit-breaker is recommended for the
power supply line for an intervention range of 10 to 30 rated mA.
Consult a reliable electrician.
Never pass the appliance over the extension cable that the
application is working, as this could cut the cable. Mark sure you
always know where the cable is.
Use the special cable holder for the connection of the extension
cable.
Never use the appliance when it is raining. Try to prevent it from
getting wet or being exposed to humidity. Do not leave it outside
overnight. Do not cut damp or wet grass.
The power supply cable should be checked regularly and
before using it each time, make sure the cable is not damaged
or old out. If the cable is not in good condition, do not use the
appliance; take it to an authorized service center instead.
Only use an extension cable that is suitable for outdoor work.
NL SV DA NO FI HU CS RU
English(Original Instruction)
SYMBOLS
Keep it away from the cutting area, from damp, wet or oily
surfaces or with sharp edges and away from heat and fuels.
Use only connection or extension cord with a maximum length of
15m and a minimum cable diameter of 0.75 mm ².
If the supply cord is damaged,it must be replaced by a special cord
or assembly available from the manufacturer or its service agent.
customer
EXTENSION CORDS
When using a cultivator at a considerable distance from
the power source, use an extension cord heavy enough
to carry the current that the tool will draw. An undersized
extension cord will cause a drop in line voltage, resulting in
a loss of power and causing the motor to overheat.
Before using an extension cord, inspect it for loose or
exposed wires and cut or worn insulation.
FEATURES
PRODUCT SPECIFICATIONS
Rated power
Rated voltage
Noload speed
Vibration
Sound pressure level
Guaranteed sound power level
Weight (without cord)
Protection degree
15
RO PL SL HR ET LT
WARNING:
Keep the extension cord clear of the tines and
working area. Position the cord so that it will not
get caught on lumber, tools or other obstructions
while you are working with a cultivator. Failure to
do so can result in serious personal injury.
WARNING:
Check extension cords before each use. If
damaged replace immediately. Never use tool
with a damaged cord since touching the damaged
area could cause electrical shock resulting in
serious injury.
3.2 m/s
LpA:80dB(A) KpA:2dB(A)
LV SK BG
950 W
220-20V ~ 50Hz
30 /min
², k=1.5 m/s²
93dB(A)
1. kg
IPX4