Fitting/Removing Attachments - Russell Hobbs Desire 23480-56 Mode D'emploi

Fitting the bowl
Raise the arm before fitting or removing the bowl. Use only the bowl supplied.
1. Fit the bowl into the recess in the base and turn it clockwise until it locks.
2. To remove, turn it anti-clockwise then lift it off the base.

Fitting/removing attachments

Switch off, unplug and raise the arm before fitting or removing attachments.
1. Align the slot in the attachment with the pin on the drive shaft (Fig A).
2. Push the attachment onto the drive shaft then turn it anti-clockwise to lock it (Fig B).
To remove an attachment, push it upwards slightly then turn it clockwise and pull it off the shaft.
Splash guard
The splash guard protects you from spills or splashes during mixing while still allowing you to add
ingredients. Switch off and unplug your mixer before fitting/removing the splash guard.
With the bowl in position and the arm in the lowered position:
1. Slide the splash guard between the arm and the bowl.
2. Align it so that the opening is on the right hand side (Fig C).
• Always remove the splash guard before raising the arm.
USING YOUR MIXER
1. Check that the speed control is set to O.
2. Put the plug into the power socket (switch the socket on, if its switchable).
3. Turn the speed control clockwise to the speed you want.
4. The range is from 1 (low) to 10 (high). Turn the speed control back to O to turn the motor off.
To operate the motor in short bursts, turn the speed control to the Y position. Release the control to
5.
stop the motor.
Recommended Speeds
Attachment Speed
Whisk 7-10
Beater
Dough hook
ASSEMBLY
1. Slide off the blending jug drive cover (Fig D).
2. Insert the jug into the drive opening with the t mark on the jug aligned with the Umark
on the mixer (Fig E).
3. Twist the jug clockwise until the t mark on the jug is aligned with the Lmark on the mixer
(Fig F).
4. Add the ingredients to the the jug and fit the lid and cap (Fig G). Don't fill past the max
mark on the jug. Never use the jug without the lid fitted.
USING YOUR BLENDER
1. Check that the speed control is set to O.
2. Put the plug into the power socket (switch the socket on, if its switchable).
3. Turn the speed control clockwise to the speed you want.
4. The range is from 1 (low) to 10 (high). Turn the speed control back to O to turn the motor off.
To operate the motor in short bursts, turn the speed control to the Y position. Release the control to
5.
stop the motor.
6. If you need to add other ingredients during blending, turn the cap anticlockwise and lift it off. Add
the ingredients then replace the cap and turn it clockwise to lock it.
When you have finished blending, turn the speed control to O and wait for the blades to stop before
7.
removing the lid from the jug or the jug from the mixer.
8. To remove the jug, twist it anticlockwise until the t mark is aligned with the Umark.
Use for
beating/aerating cream, egg whites, batter, light mixes
4-7 creaming butter and sugar, medium cake mixes
1-3 heavy mixtures, bread, pastry
BLENDER
5