Stimulation On/Off; Signal Strength - Boston Scientific Vercise DBS Mode D'emploi

Stimulation On/Off

Stimulation is turned on and off via a dedicated power switch on the Remote Control
keypad. Simply press the stimulation on/off button
Remote Control is in sleep mode – to change the stimulation status of the Stimulator.

Signal Strength

The Remote Control indicates the signal strength between itself and the Stimulator in
the upper right corner of the display:
Signal Strength
The Remote Control is achieving optimal communication with
your Stimulator.
The Remote Control is achieving good communication with
your Stimulator.
The Remote Control is achieving OK communication with your
Stimulator.
The Remote Control is achieving weak communication with
your Stimulator.
The Remote Control is achieving either very weak or no
communication with your Stimulator.
Communication between the Remote Control and the
Stimulator may or may not be achieved. To improve the
communication speed, move the Remote Control closer to
the Stimulator and position it as shown on page 47.
After missing a telemetry message, the Remote Control will display the "Searching"
screen. The Remote Control will then start looking for signal strength every second.
Move to a better spot and wait for the signal strength to display. To cancel searching
press .
Note: Avoid common sources of interference, such as televisions and computer
monitors when trying to use the Remote Control.
at any time – even when the
Description
91098825-07 Rev A 49 of 333
The Remote Control
Physician Manual