Boston Scientific Vercise DBS Mode D'emploi page 52

Physician Manual
The Remote Control will display the following message upon first activation (when
any button is pressed):
1. Ensure the Remote Control is within telemetry range of the Stimulator (60 cm
or 2 ft).
P
2. Press to initiate communication between the Remote Control and the
Stimulator. The Remote Control will identify the Stimulator by ID number.
P
3. Press to confirm and continue.
The Remote Control will automatically detect available program sets in the Remote
Control or Stimulator. If there are no available programs, the link will be completed
immediately and you will see the screen below:
However, if programs are present in either device (Remote Control or Stimulator)
during linking, you will be required to respond to one or more decision screens.
Your decisions will guide the Remote Control to complete the linking with the
desired program set saved to the desired device (Remote Control or Stimulator).
You may also need to enter the clinician's password.
If an error occurs during the process or if the password is incorrect linking will
be aborted. For further information, including information about the clinician's
password, see Selection #3 – Clear Link in the Clinician Options section.
Physician Manual
91098825-07 Rev A 48 of 333