Bosch RIESE & MULLER BDU330 Mode D'emploi page 75

English – 6
EN-144
Product description and specifications
Intended use
The drive unit is intended exclusively for driving your
eBike and must not be used for any other purpose.
Technical data
Drive unit
Product code
Continuous rated power
Torque at drive, max.
Rated voltage
Operating temperature
Storage temperature
Protection rating
Weight, approx.
A) Is determined by the bicycle manufacturer
The Bosch eBike system uses FreeRTOS (see http://www.freertos.org).
Bicycle lights A)
Voltage approx. B)
Maximum power
– Front light
– Rear light
A) Depends on legal regulations, not possible in all country-specific models via the eBike battery
B) When changing the bulbs, ensure that they are compatible with the Bosch eBike system (ask your bicycle dealer) and are suit-
able for the specified voltage. Bulbs must only be replaced with bulbs of the same voltage.
Inserting a bulb incorrectly can cause it to blow.
0 275 U07 XD4 | (09.04.2020)
In addition to the functions outlined here, changes to
software relating to troubleshooting and functional
modifications may be introduced at any time.
Performance Line CX/ Performance Line Speed/
Cargo Line Cargo Line Speed
BDU480 CX
W 250
Nm 85
V= 36
°F +23 to +104
°F +50 to +104
IP 54
kg 3
V= 12
W 17.4
W 0.6
Inserting and removing the battery
For inserting and removing the eBike battery in/from
the eBike, please read and observe the battery oper-
ating instructions.
Check speed sensor
A
BDU490P
250
75/85 A)
36
+23 to +104
+50 to +104
IP 54
(3)
3
(1) Speed sensor (standard)
(2) Spoke magnet
(3) Speed sensor (slim)
(4) Magnet
A) Different sensor shape and installation position possible
Speed Sensor (standard)
The speed sensor (1) and its spoke magnet (2) must
be fitted such that the spoke magnet moves past the
speed sensor at a distance of at least 5 mm and at
most 17 mm with each rotation of the wheel.
Note: If the distance between the speed sensor (1)
and the spoke magnet (2) is too small or too large, or
if the speed sensor (1) is not properly connected, the
speedometer display will fail and the eBike drive unit
will operate in emergency mode.
Should this occur, loosen the screw of the spoke mag-
net (2) and fasten the spoke magnet to the spoke
such that it runs past the marking on the speed sen-
sor at the correct clearance. If the speed is still not
Bosch eBike Systems Bosch eBike Systems
Assembly
being indicated on the speedometer display after do-
ing this, please contact an authorized bicycle dealer.
Speed Sensor (slim)
The speed sensor (slim) (3) and its spoke magnet (4)
must be fitted ex works such that the spoke magnet
moves past the speed sensor at a distance of at least
2 mm and at most 8 mm with each rotation of the
wheel.
The correct distance between the magnet and sensor
must be maintained (see figure A) if design changes
are made.
Notes: Ensure that you do not damage the sensor or
sensor bracket when fitting or removing the rear
(1) wheel.
(4)
(2)
A)
English – 7
EN-145
0 275 U07 XD4 | (09.04.2020)