Bosch RIESE & MULLER BDU330 Mode D'emploi page 60

EN-114
smartphone in your hand while cycling on public
streets.
Consult a doctor before using fitness app pro-
u
grams. Fitness apps may cause people to overexert
themselves physically.
Note: We recommend that COBI.Bike products are
only used by persons at least 10 years of age.
Safety Instructions for Charging the On-
Board Computer Battery
Only charge the on-board computer with USB
u
power source (5 V, 1000 mA max) and USB ca-
ble rated at least 1000 mA. Using USB power
source or USB cable not appropriately rated for the
application may result in fire, explosion or personal
injury.
Charge the on-board computer in temperatures
u
above +32 degrees F (0 degrees C) and below
+104 degrees F (40 degrees C). Store on-board
computer in locations where temperatures will
not exceed 104 degrees F (40 degrees C). This is
important to prevent serious damage to the battery
in the on-board computer.
Do not expose on-board computer to fire or ex-
u
cessive temperature. Exposure to fire or tempera-
ture above 212 °F (100 °C) may cause explosion.
Do not recharge the on-board computer (via
u
USB port) in damp or wet environment. Water
entering on-board computer may result in electric
shock or fire.
Never submerge on-board computer in fluid of
u
any kind or allow fluid to enter them. Corrosive
or conductive fluid (such as seawater or industrial
chemical or bleach containing products, etc.) can
cause short circuit which may result in fire, per-
sonal injury and property damage.
Battery leakage may occur under extreme usage
u
or temperature conditions. Avoid contact with
skin and eyes. The battery liquid is caustic and
could cause chemical burns to tissues. If liquid
comes in contact with skin, wash quickly with soap
Bosch eBike Systems
English – 5
and water. If the liquid contacts your eyes, immedi-
ately flush eyes with water for a minimum of
15 minutes and seek medical attention.
Place on-board computer on flat nonflammable
u
surfaces and away from flammable materials
when recharging on-board computer using ex-
ternal USB power source. Carpeting and other
heat insulating surfaces block proper air circulation
which may cause overheating of the on-board com-
puter. If smoke or melting of the on-board com-
puter is observed, unplug the external USB power
source immediately and do not use the on-board
computer. Contact customer service immediately.
Before each use, check the on-board computer,
u
cable and plug. If damage is detected, do not use
the on-board computer. Damaged on-board com-
puter, charging cables and plugs increase the risk
of a fire, explosion and personal injury.
Do not disassemble on-board computer. No user
u
serviceable part inside. Incorrect reassembly or
damage may result in fire or explosion.
NOTICE: This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environ-
ment. This equipment should be installed and oper-
ated with minimum distance of 20 cm between the
radiator and your body. This transmitter must not be
co-located or operating in conjunction with any other
antenna or transmitter:
1. This device must not cause harmful interference,
and
2. this device must accept any interference that is re-
ceived, including interference that may cause un-
desired operation.
NOTICE: Changes or modifications made to this
equipment not expressly approved by the Robert
Bosch GmbH may void the FCC authorization to oper-
ate this equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against
1 270 U20 XBC | (29.04.2020)
English – 6
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful inter-
ference to radio communications. However, there is
no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following mea-
sures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
– Consult the dealer or an experienced radio/TV tech-
nician for help.
Radiofrequency radiation exposure Information:
The radiated output power of the device is far below
the FCC radio frequency exposure limits. Neverthe-
1 270 U20 XBC | (29.04.2020)
less, the device shall be used in such a manner that
the potential for human contact during normal opera-
tion is minimized.
ISED Notice (Canada)
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the
following two conditions:
– this device may not cause interference, and
– this device must accept any interference, including
interference that may cause undesired operation of
the device.
This equipment complies with FCC radiation expo-
sure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with
minimum distance of 20 cm between the radiator and
your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or
transmitter.
Privacy notice
If the SmartphoneHub is sent to Bosch Service for
servicing, note that the data stored on the device may
be transmitted to Bosch.
Bosch eBike Systems
EN-115