Vehicle make records
To access select the
icons.
Position the cursor on the make card, select it
with ↵ to visualise and/or modify it.
The fields highlighted in blue are compulsory.
during vehicle selection, identifies the
new makes entered by the user, not accompanied
by the specific graphic logo.
CALIBRATION
Refer to the service manual.
IMPROPER USE
The Personal Computer installed in the central
unit should only be used with the programmes
supplied by the producer.
CAUTION
You are strongly advised not to use the Personal
Computer for games or with other software
based on unauthorised copies, to avoid reduc-
ing the safety of plants and persons. This is
mandatory to avoid any possible contamination
from viruses.
In any case, you are advised to check the compat-
ibility of all original software not supplied by the
producer with the Technical Service.
CAUTION
Do not remove the Personal Computer from
its installation position to avoid any damage
to the connections.
Operator's manual EXACT LINEAR
ENCOUNTERED VEHICLE
,
and
Vehicle tends to wander to the left or the right.
Cause: tyre side slip.
Invert the position of the wheels on the same axle:
If the vehicle now tends to wander to the other
side, take one of the wheels whose position you
have already inverted and turn the tyre on the rim.
If the wander direction does not change per-
form the same operation on the wheels of the
other axle.
If this double inversion procedure fails to solve
the problem, check that camber values on the
same axle are identical, make the same compari-
son for caster values.
Steering wheel not aligned with vehicle path
Possible causes:
- Mechanical backlash.
- Compensation has been skipped or performed
incorrectly.
- Wheel alignment performed using the two-
target procedure.
- Wheel alignment performed with the steering
wheel off centre.
- Front wheels adjusted with respect to the axis
of symmetry.
Disparity between steering locks.
The steering box range must be centred by
counting the number of steering wheel revolu-
tions from full lock to full lock.
Position the steering wheel in the centre of its
range, clamp the steering wheel and perform
the normal procedure for adjustment of the front
half toe values.
Position the steering wheels correctly, disas-
sembling it from the steering column if needs be.
Steering wheel is excessively stiff with vehicle
stopped.
Possible causes:
- Excessive caster.
- Incorrect king pin angle.
- Excessive camber.
Steering wheel return is too low or too forceful
when driving.
Incorrect caster value - adjust.
Tyre wear.
- Tyres with irregular wear on both side walls:
MOST COMMONLY
ALIGNMENT FAULTS
EN
69