Job Record; 2-Target Mode - Corghi EXACT LINEAR Manuel D'utilisation

shows the toe, camber and setback values before
and after adjustment.
The second annex, entitled "Chassis Situation",
lists the set-back, track difference, wheel base
difference, side offset and offset values of the
axles after adjustment.
The "Print \ Type" field of the user set-up can
be set appropriately to select the annexes to
be printed:
• "Alphanumeric" prints the alphanumeric pages
only.
• "Vehicle Situation" prints the alphanumeric
report and the vehicle situation annex. This
setting is indicated by the
print page status bar.
• "Chassis Situation" prints the alphanumeric
report and the chassis situation annex. This
setting is indicated by the
the print page status bar.
• "Complete" prints the alphanumeric report
and both annexes.
The set-up can be varied on the print page.
PRINT ON FILE. If selected, allows the
data to be printed in a CSV (Comma Separated
Values) file.
COLOUR PRINT. If selected, the printed
reports will be in colour.
PRINT PRELIMINARY CHECKS. The
preliminary check reports are printed.
ALPHANUMERIC PRINT (standard).
VEHICLE SITUATION GRAPHIC PRINT.
CHASSIS SITUATION GRAPHIC PRINT.
64
From the printing stage, access the job record
using the
instead of selection of the vehicle from the da-
tabank can also be set in the set-up.
Another setting that can be made in the set-up
is the type of job record to be used.
Fill in the job record by using the keys as de-
scribed in the "DATABANK MANAGEMENT"
section.
The compulsory fields are highlighted.
icon in the
When a customer or vehicle is selected from
those already on file, the relative data are
loaded in the job record (e.g., when a vehicle
is selected by means of the registration num-
ber, the customer and the vehicle saved in
the vehicle record are automatically loaded).
These data overwrite those entered previously,
so the selected vehicle may be modified in the
icon in
databank.
When a new value is entered in the REG.N.,
CHASSIS and CUSTOMER fields, a new record
is automatically opened for data input.
When the job done is saved, the vehicle and
customer records are also automatically updated.
The following procedure allows you to align just
the front axle of the vehicle. It is recommended
for caravans or vans for which it is not possible
to mount the brackets and targets on the rear
axle, due to the fairing of the vehicle.
1) Mount only the front 2 target and clamps.
2) Select the mode ROC and continue.
3) Make the steering.
4) Adjust the front axle.
5) If necessary, make the second steering.
6) Adjust the front axle.
7) The procedure is terminated on the Print page.
NOTE: the measurement in 2-target mode
does not guarantee that the steering wheel is
perfectly straight, as the rear axle reference is
not calculated.

JOB RECORD

icon. Use of the job record
WARNING

2-TARGET MODE

Operator's manual EXACT LINEAR