Main Working Elements Of The Machine; Personal Computer; Important - Corghi EXACT LINEAR Manuel D'utilisation

MAIN WORKING
ELEMENTS OF THE
MACHINE
WARNING
Get to know your machine. The best way to
prevent accidents and obtain top performance
from the machine is to ensure that all operators
know how the machine works.
Learn the function and location of all commands.
Carefully check that all the commands on the
machine are working properly.
To avoid accidents and injury, the machine must
be installed properly, correctly operated and
regularly serviced.
Central unit (Fig. 1)
- Monitor: shows the working screens with
the diagrams of the angles measured; the
operating commands are in the bottom part.
- Keypad: used to select the commands avail-
able and enter alphanumerical data.
The ENTER key recalls the command se-
lected by the arrow keys.
The ESC key returns the programme to the
previous step.
- Personal Computer: contains and executes
the vehicle wheel alignment program.
- Printer: allows the results of the job done to
be recorded on paper.
- Power supply plug.
- Electrical board.
Working screen (Fig. 19)
A) Title (e.g. FRONT AXLE): indicates the pro-
cedure being used.
B) Values measured on the vehicle.
C) Databank values.
D) Graphic comparison between the values
measured and databank values.
E) Target level indications (LEVELS).
F) Representation of the angles currently being
measured.
G) HELP: command which recalls the on-line
help function.
H) Icon bar: icons you can use to move around
the program. More information about the
selected icon is provided in the feedback
bar.
I) Feedback bar: displays a help message about
the function of the selected icon.
46
L) Vehicle name bar: displays the name of the
vehicle selected from the databank. During
selection of the vehicle from the databank,
it shows the market selected.
M) Status bar: displays system messages.
N) Axle value difference: window containing the
value and databank reference for the differ-
ence between the right-hand and left-hand
values of the angle measured. The window
only appears when the databank contains a
reference value.
O) Operating Zone: part of the screen which
displays the working information.
Target (Fig. 3)
A) Locking knob of the target to the bracket.
Clamps
The clamps function in the same way as ordinary
self-centring clamps.
Use the handle (A Fig. 3) to fix the clamp to the
rim or remove it.

PERSONAL COMPUTER

Turn on the aligner using the main switch.
Wait a few seconds to allow the monitor to switch
on and the computer to load the program.
The personal computer, and thus the entire wheel
aligner, can only be switched off using the com-
mand provided in the wheel alignment program.

IMPORTANT

Switching off the personal computer without
using the command provided may damage the
software installation.
IMPORTANT
When the wheel aligner is switched off using
the software command, the PC, the monitor and
the printer switch to standby status. To switch
off these devices completely, use either the
relative on and off buttons, or the PC feeder
switch (switch marked C turned to 0), or cut off
the wheel aligner power supply at the mains.
Keep the original MS-WINDOWS and aligner
software CD-ROMs for future system updates.
Operator's manual EXACT LINEAR