Corghi EXACT LINEAR Manuel D'utilisation page 53

Characteristic angle symbols for
data summary screens
In the data summary screens, the vehicle's
characteristic angles are referred to by means
of graphic symbols.
Total front toe
Total rear toe
Front LH half toe
Rear LH half toe
Front RH half toe
Rear RH half toe.
LH front camber
LH rear camber
RH front camber
RH rear camber
LH front caster
Thrust angle
RH front caster
Rear setback
LH front king pin
RH front king pin
Track difference
LH included angle
RH included angle
LH side offset
Front LH steering angle difference.
Operator's manual EXACT LINEAR
RH side offset
Front RH steering angle difference
Axle offset
LH front maximum steering angle
Wheel base difference
RH front maximum steering angle
Front setback
Toe curve
Chassis height
Measurement unit (Fig. 4)
The measurement unit of the aligner is com-
posed of two units consisting of a camera and
a card with infrared LED and signal LED light,
positioned at the edge of the beam. In Figure 4
is shown one measurement unit, in particular:
1) Protective Cover
2) Camera
3) CUBOLED Card, consisting of infrared LEDs
and LED indicator lights.
Light Indications cards CUBOLED
(Fig. 5)
Around each camera is placed the CUBOLED
card equipped with infrared illuminators and
some colored LEDs, which are used to provide
useful information to the user.
The following table shows the conditions indi-
cated by colored LEDs:
LINK LED (bi-color, illuminated in red or
green):
There are 4 external LEDs that indicate the sta-
tus of the locking target.
RG1) LINK LED for the front left target
RG2) LINK LED for the front right target
RG3) LINK LED for the rear right target
RG4) LINK LED for the rear left target
EN
53