The System Setting Menu „System - Reely HCP80 3D RtF Notice D'emploi

13. The System Setting Menu „SYSTEM"
The basic settings of the remote control transmitter are made in the system setup menu first. These settings are not
referred to individual models. The specific settings of the individual models are only made afterwards in the function
setting menu (see chapter 14).
To get to the system settings menu, switch the transmitter on and push the „SELECT" button. The operation of a button
at the transmitter is confirmed by a short signal sound.
The display shows the two main menus „Function" and „System". The menu „Function" already has a black back-
ground. You can use the buttons „UP" and „DOWN" to give the menu „System" a black background and call it by
pushing the „SELECT" button again.
The first 4 menu items of the system setting menu are now displayed.
The following setting functions are available to you in the system setting menu:
Function
Model name settings
Model memory selection
Copying model memory
Reset model memory
Model type selection
Control stick assignment
Calibrate pitch stick middle position
To leave the system setting menu again and to return
to the operating system, push the „CLEAR" button
twice.
90
Display
„1: MDL NAME"
„2: MDL SEL"
„3: MDL COPY"
„4: MDL RST"
„5: MDL TYPE"
„6: STK TYPE"
„7: STK ADJ"
Figure 22