Replacing The Tail Rotor Propeller; Checking The Screw Connections - Reely HCP80 3D RtF Notice D'emploi

b) Replacing the Tail Rotor Propeller
The propeller of the tail rotor (1) is pushed onto the motor shaft
(2) and can be easily removed from the shaft.
Pull off the defective propeller with the fingers and ensure that
the motor shaft is not bent when pulling it off and pushing it on.
c) Checking the Screw Connections
Regularly check all screw connections of your helicopter for
tight fit.
Particularly observe the screws (1 and 2) at the rotor shaft.
When replacing mechanical parts use only original spares available from the manufacturer.
The spare parts list is located on our website www.conrad.com in the download section to the respective
product.
Alternatively, you may also request the spare parts list on the phone. The contact information is included at
the beginning of these operating instructions, chapter „Introduction".
120
Figure 53
Figure 54