Setting Up The Transmitter; Selecting Remote Control Mode - Reely Piper J3 Cub Notice D'emploi



9. Setting Up the Transmitter

In practice, it has turned out helpful to first take the transmitter into operation and then charge the flight
battery with the transmitter. The model can be competed during charging.
a) Selecting Remote Control Mode
With the help of the mode switch (also see figure 2, item 3), the remote control cannot be operated in mode 1 or mode
2. If the switch is pushed to the left position, mode 1 is activated. If the switch is pushed to the right position, mode 2 is
activated.
The two modes differ only by assignment of the control functions of the respective control lever.
Mode 1:
Right control stick forward and backward:
Motor function (THRO)
Right control lever right and left:
Rudder function (RUDD)
Left control stick forward and backward:
Elevator function (ELEV)
Left control lever right and left:
No function
Mode 2:
Right control stick forward and backward:
Elevator function (ELEV)
Right control lever right and left:
Rudder function (RUDD)
Left control stick forward and backward:
Motor function (THRO)
Left control lever right and left:
No function
Other information on model control can be taken from the section „Checking the Control Functions".
40
Figure 3