Reely HCP80 3D RtF Notice D'emploi page 74

In the backlit display (also see figure 1, item 11), first „H-6" is
the display briefly.
Then a short signal sounds, the LED (also see figure 1, item 21)
lights up and the display shows the operating display.
Attention!
If the toggle switches „Flight Mode" or „Throttle hold" and the control stick for the pitch and tail functions
„Thro.Stick" are in the wrong position, the corresponding warning note is displayed. The transmitter also
emits acoustic warnings in a quick sequence.
If the warning message „Thro.Stick" does not go out in spite of the correct position of the control stick for the
pitch and tail function, the wrong control stick mode is probably set in the system setting menu. For more
information about this, see chapter 13.
The operating display consists of the following elements:
1 Battery symbol
2 Transmitter voltage/timer display
3 Model type symbol
4 Nod-trim display (mode 2)
5 Flight condition display
6 Control stick path display
7 Roll-trim display (mode 2)
8 Tail-trim display (mode 2)
9 Display of the last control stick actuated
10 Model name
11 Pitch-trim display (mode 2)
12 Control stick mode display
If the power supply is no longer sufficient for a faultless operation of the transmitter (less than 4 V), the LED
display flashes and the transmitter emits short alarms at regular intervals.
In this case, terminate flight operation of the model immediately and insert a new set of batteries in the
transmitter.
74
Figure 4b
Figure 5