• Push the button „DOWN" to save the horizontal deflection to
the left „Hori axis LEFT" of the left control stick.
• The calibration points of the left control stick are saved ac-
cording to the same principle as for the right one.
• Save the three different control stick positions for the horizon-
tal and vertical movement directions each.
• After the last calibration point has been saved, the display
loop starts again with the first display value of the right con-
trol stick.
• Push the buttons „UP" and „DOWN" at the same time to
leave the „ENGINEER" mode.
16. Maintenance and Care
Clean the exterior of the model and the remote control only with a soft, dry cloth or brush. Never use abrasive cleaning
agents or chemical solutions as these could damage the surfaces of the casings.
All moving parts have to be easily movable but there should not be a clearance in the bearing. The motor shafts with
the rotor shaft must be aligned perfectly straight and must not be eccentric.
a) Replacing the Rotor Blades
If contact with an obstacle leaves visible danger on a rotor blade
(cracks or broken parts), the rotor blade must be replaced.
When replacing the rotor blades (1), observe the rotating direc-
tion and do not tighten the attachment screws (2) too firmly.
The rotor blades must be able to align downwards on their own
when the helicopter is tilted to the side.
Figure 51
Figure 52
119