Setting The Angle Of Attach Of The Outboard Motor - Reely Hornet Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Low water volumes entering (max. approx. 10 ml per trip) is normal; it must be emptied after every operation.
After a trip, the motor and speed control must cool off to ambience temperature. Therefore, make a break
of approx. 5 to 10 minutes before the next trip. The hull deck should remain disassembled for better
cooling.
f) Setting the Angle of Attac of the Outboard Motor
If the two screws (figure 8, item 1) are loosened, you may adjust the angle of attack of the outboard motor to the
fuselage boat (figure 8, item 2). This makes it possible to adjust the sliding properties of the model. After adjustment,
both screws must be tightened again.
The sliding properties depend on the body of water (e.g. waves) and the rechargeable batteries used
(weight or trimming). You need to find out the best setting in test runs.
Figure 8 also shows the water cooling inlet (item 3) and water outlet (item 4).
Figure 8
41

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

27 54 40

Table des Matières