Mixer Programming „Pro Mix1" And „Pro Mix2 - Reely HCP80 3D RtF Notice D'emploi

Hélicoptère 3d
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

k) Mixer Programming „PRO MIX1" and „PRO MIX2"
The remote control offers the option of mixing two control channels. In a flight model, the function is used often, e.g.
to also automatically generate an elevator deflection when extending the landing or spoiler flaps, so that the model
airplane does not change its horizontal flight position. For the helicopter model „HCP80 3D", these mixers are not
needed and therefore need to be switched off.
Proceed as follows for mixer programming:
• Call the function settings menu.
• Select the menu item „PRO MIX1" or „PRO MIX2" with the
buttons „UP" or „DOWN".
• Activate the menu item with the button „SELECT".
The display shows the master and slave functions as well as
the setting values for the mixing shares and the offset value.
All displayed setting values should be set to „0" and the func-
tion of the mixer should be off (setting „SW: INH").
• Push the button „SELECT" to call the specific setting values
when required.
• Pushing the buttons „INC (+)" or „DEC (-)" permits changing
the set values or setting them to „0".
• Set all setting values to „0" and switch off the mixer (setting
„SW: INH"), if it is activated.
• The setting is saved automatically.
• Push the button „CLEAR" to get back into the overview of the
function setting menu.
114
Figure 46

Publicité

Table des Matières
loading

Table des Matières