Setting Up The Transmitter; Inserting The Batteries - Reely Micro Beaver RtF Notice D'emploi

9. Setting up the Transmitter

a) Inserting the Batteries
Important!
Only operate the remote control transmitter with batteries with a voltage of 1.5 V/cell. Rechargeable bat-
teries (NiCd/NiMH) only have a voltage of 1.2 V/cell and therefore are not suitable for power supply to the
transmitter or the charge function (flight battery) that is integrated in the transmitter.
Proceed as follows to insert the batteries:
The battery compartment lid (1) is located on the back of the transmitter. Push the locking lever (2) at the upper edge
of the battery compartment lid slightly down and lift off the lid.
Now insert 4 batteries of type AA/Mignon (high-quality alkaline batteries recommended) into the battery compartment.
Be sure to observe the correct polarity of the individual cells (note plus/+ and minus/-). A corresponding note (3) is
located on the bottom of the battery compartment.
Then place the battery compartment lid with the bottom edge first into the transmitter housing and let the latching lever
latch properly when pushing on.
Figure 2
37