Reely HCP80 3D RtF Notice D'emploi page 104

The chart does not show the complete control characteristic curve. The left edge corresponds to the middle
position and the right edge to the max. deflection.
• Push the button „SELECT" so that the input function will jump down to the dual rate input value „DR" (bottom-most
display figure in figure 35).
• Pushing the buttons „INC (+)" or „DEC (-)" sets the described dual rate value for the roll servo. The lower the value
set, the lower the servo end deflection.
• The setting is saved automatically.
• Push the toggle switch „Dual Rate" backwards towards the
body so that the display „AILE0" jumps to „AILE1" for re-
duced deflection values.
• Programming of the dual rate and exponential values in this
setting works according to the same principle as in the large
deflections.
• When you have set all dual rate and exponential values for
the roll function, push button „SELECT" so that the display
„AILE0" or „AILE1" has a black background.
• Now use the buttons „INC (+)" or „DEC (-)" to switch to the
function „ELEV0"/„ELEV1" or „RUDD0"/„RUDD1" and also
set the dual rate and exponential values there according to
the same principle.
• Push the button „CLEAR" to get back into the overview of the
function setting menu.
104
Figure 36
Figure 37