Copying Model Memory „Mdl Copy - Reely HCP80 3D RtF Notice D'emploi

c) Copying Model Memory „MDL COPY"
For simple programming of the system you have the option of copying data from one currently activated model
memory to another. This way the factory parameters can be left in a model memory and individual changes can be
made to the copied model memory without the factory settings being lost.
To copy the data from one model memory into another, proceed as follows:
• Call the system settings menu.
• Select the menu item „MDL COPY" with the buttons „UP" or
„DOWN".
• Activate the menu item with the button „SELECT".
The display shows the currently called model memory, the
modulation type and the model type and the model name.
The bottom line shows the target memory „MODEL 1....
MODEL 10".
• Pushing the buttons „INC (+)" and „DEC (-)" sets the desired
target memory into which the data are copied.
• Push the button „SELECT" to start copying. The display
of the target memory is concealed and the display „Copy
Finished" will appear after successful copying.
• Push the button „CLEAR" to get back into the overview of the
system setting menu.
• Select the target memory and check if copying has been per-
formed correctly.
Figure 25
93