Setting Up The Transmitter; Inserting The Batteries - Reely 1527787 Notice D'emploi

All manuals and user guides at all-guides.com

9. Setting up the Transmitter

In the further course of these instructions, figures in the text always refer to the adjacent figure or the figures
within the section. References to other figures are indicated with the corresponding figure number.
a) Inserting the Batteries
The power supply of the transmitter requires 4 AA/mignon batteries (e.g. Conrad Item No. 652506, please order 4x).
Proceed as follows to insert the batteries:
Loosen the retention screw (1) of the battery compartment
lid (2) on the back of the transmitter and push off the bat-
tery compartment lid downwards.
Insert the batteries observing the correct polarity accord-
ing to the note in the battery compartment (3). The spiral-
shaped spring contact (4) always must be connected to
the minus pole of the battery.
Push on the battery compartment lid again from below and
tighten the retention screw (1).
Figure 2
27