Reely HCP80 3D RtF Notice D'emploi page 107

To set the gyro sensitivity, proceed as follows:
• Call the function settings menu.
• Select the menu item „GYRO SEN" with the buttons „UP" or
„DOWN".
• Activate the menu item with the button „SELECT".
• The display shows the display of the gyro sensitivity for the
switch positions „POS0", „POS1" and „POS2". Since the rock-
er switch can only call the positions „POS0" and „POS1", the
setting „POS2" is not relevant and can be left on 0.
• The triangle pointing to the right shows that the value for the
switch position 0 (switch position to the front) can be set.
• Pushing the buttons „INC (+)" or „DEC (-)" permits changing
the value of the gyro sensitivity in the area from 0 to 100.
• The setting is saved automatically.
• Push the button „SELECT" so that the triangle pointing to the
right will jump down to the switch position 1 (switch position
to the rear).
• The setting is made the same way as that for switch
position 0.
• Push the button „CLEAR" to get back into the overview of the
function setting menu.
The values shown in figure 39 should only point out the adjustment options. They do not serve as reference
values for the setting.
Since the helicopter is already pre-set ex works, you should only make very small changes and check the
changed settings with test flights.
Figure 39
107