Mennekes ACU Instructions D'installation page 58

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 74
ACU-Network – GPRS configuration
The ACU has a built-in modem and can communicate with
the backend of the charging network operator via GPRS.
Fig. 15: ACU-Network – GPRS configuration
To avoid unnecessary costs, the SIM card should have a
flat rate for data volume.
Depending on the backend used, further requirements
on the SIM card may exist that are not covered in this
documentation.
Requirements:
 The ACU uses a valid SIM card.
 The ACU is not connected to a backend via the LAN
interface.
 You have valid login details (access point name, user
name and password) of your mobile service provider.
22
22
Parameters
Description
Use GPRS
Activate when using mobile
connection
communication to backend system over
GPRS.
APN
Input: Access point name of your mobile
service provider.
LTE Auth
 LTE authorization enabled
 LTE authorization disabled
This setting is useful if the LTE network is
too unstable.
2G only
 Only 2G connection enabled
 Only 2G connection disabled
If "2G only" is enabled, the ACU only
connects to the 2G network. This setting
makes sense if the UMTS and LTE
networks are too unstable.
CHAP
 CHAP authentication enabled
 CHAP authentication disabled (PAP
authentication is used)
Ask your network service provider if CHAP
or PAP is being used.
Name
Input: User name for your mobile service
access.
Pass
Input: Password of your mobile service
access.
Ping server 1,
Input: ping1.mennekes.de /
Ping server 2
ping2.mennekes.de (or corresponding
server address of the backend operator).
GPRS
Status of the GPRS connection.
connection
data
SIM card
Status of the SIM card.
Signal quality
Signal quality status (0 - 31).
rssi (according to 3GPP TS 27.007)
Operator:
Display of the mobile phone network /
mobile service provider

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Scu

Table des Matières