2 For your safety
2.1 Target groups
As a qualified electrician, you have received recognised
electrotechnical training. Based on this knowledge, you are
authorized to carry out the electrotechnical work requested
in this manual.
Requirements for qualified electricians:
Knowledge of general and special safety and accident
prevention guidelines.
Knowledge of electrotechnical regulations.
Knowledge of national regulations.
Ability to identify risks and avoid possible hazards.
2.2 Intended Use
This MENNEKES ACU is intended for networking with a
charging infrastructure and a backend system. The ACU
serves exclusively for the communication between
connected charging systems and backend through RS-
485 bus, LAN or mobile telephone system.
The ACU can be used to network MENNEKES charging
systems that have an SCU or HCC3.
An ACU is installed in the MENNEKES eMobility Gateway
and in a Smart charging column, which is intended for fixed
installation indoors and outdoors.
Read and observe these instructions as well as all additional
documentation for use.
4
4
2.3 Inappropriateuse
Using the device is safe only when used as intended. Any
other use and changes to the device is contrary to the
regulations and therefore not permitted.
The operator is responsible for the proper and safe use.
MENNEKES Elektrotechnik GmbH & Co. KG accepts no
liability for any consequences arising from improper use of
the device.
2.4 Basic safety information
Observance of local conditions
If the configuration is not adapted to the local conditions
(e.g. cable length of the supply line), this will impair the
operational safety. This can seriously injure or kill people.
Adapt the configuration to the local conditions.
Observing supervisory duties
Persons, especially children, and animals who are not fully
able to assess potential hazards pose a danger to themselves
and others.
Keep away from the device, charging cable, tools and
packaging.