Publicité
progress.
The machine does not firmly rest on the floor.
Make sure that the floor support is firm.
➥
The wheel is not locked correctly.
➥ Tighten the securing ring nut correctly.
The machine has not been calibrated correctly.
➥ Carry out the sensitivity calibration procedure.
The entered geometric data are not correct.
Check that the data corresponds to the dimensions of the wheel and correct, if
➥
necessary.
Carry out the external sensor calibration procedure (width).
➥
WARNING
The "Spare parts" handbook does not authorise the user to carry out work on the
machine with the exception of those operations explicitly described in the User
Manual. It only enables the user to provide the technical assistance service with
precise information, to minimise delays.
WARNING
The company is not to be held responsible for any claims deriving from the use of
non-original spare parts or accessories.
WARNING
Unplug the machine from the power supply and make sure that all moving parts
have been locked before performing any adjustment or maintenance operation.
Do not remove or modify any part of the machine (except for service interventions).
CAUTION
Keep the work area clean.
Never use compressed air and/or jets of water to remove dirt or residues from
the machine.
Take all possible measures to prevent dust from building up or raising during clean-
ing operations.
Keep the wheel balancer shaft, the securing ring nut, the centring cones and flange
clean. These components can be cleaned using a brush previously dripped in environ-
mentally friendly solvents.
Handle cones and flanges carefully so as to avoid accidental dropping and subsequent
damage that would affect centring accuracy.
After use, store cones and flanges in a place where they are suitably protected from
dust and dirt.
If necessary, use ethyl alcohol to clean the display panel.
Perform the calibration procedure at least once every six months.
Operator's manual MT 3100 - MT3200
MAINTENANCE
99
Publicité
