Publicité
Press
at any time to exit the "Hidden Weights" programme.
4 To make work easier mark the position of the unbalance Pe on the tyre. To do this,
move the wheel to a centred position and make a chalk mark at 3 o'clock if the "H3"
configuration is active, at 6 o'clock if the "H6" configuration is active and at 12 o'clock
if the "H12" configuration is active.
5 Turn the wheel to the position in which you wish to apply the first outer weight (P1)
and press
To select the exact position of the weight P1 relative to the Pe unbalance, use 3 o'clock
as a reference if the "H3" configuration is active, or 6 o'clock if the "H6" configuration
is active, or 12 o'clock if the "H12" configuration is active.
The angle between P1 and Pe must be less than 120°.
6 If the angle selected is greater than 120°, the machine displays the message shown
in Fig. 16a for approximately 3 seconds to indicate that another position must be
chosen. If the angle selected is less than 120°, the machine displays the message
shown in Fig. 16c, allowing the user to continue to the next step.
7 Turn the wheel to the position in which you wish to apply the second outer weight
(P2) and press
To select the exact position of the weight P2 relative to the Pe unbalance, use 3 o'clock
as a reference if the "H3" configuration is active, or 6 o'clock if the "H6" configuration
is active, or 12 o'clock if the "H12" configuration is active.
The angle between P1 and P2 must be less than 120° and must include the outer
weight Pe.
8 If the angle selected is greater than 120°, the machine displays Fig. 16d for approxi-
mately 3 seconds to indicate that the procedure described in step 7 must be repeated
correctly. If the angle selected is less than 120°, the machine immediately displays
the value for the weight P2. The LED
Weight" programme is active.
Operator's manual MT 3100 - MT3200
to confirm.
to confirm.
16c
will remain on to show that the "Hidden
87
Publicité
