Publicité
b) External sensor not present or faulty. Visualisation of this error can be
disabled by performing the following procedure:
- Press the
programme illuminates;
- Press the
will appear on the left display, and one flashing "E" will appear on the
right one.
E 16
Motor temperature too high. Wait before performing a new spin (do not
turn off the machine).
E 27
Excessive braking time. If the problem persists, call in the technical
support centre.
E 28
Encoder counting error. If the error occurs frequently, call in the technical
support centre.
E 30
Wheel spin device failure. Switch off the machine and call in the technical
support centre.
E 32
The wheel balancer has been jolted during the reading phase. Repeat the
wheel spin.
CAL [GO] Calibration wheel spin.
GO Alu
Wheel spin with Alu programme selected.
GO d15
Wheel spin with Motorcycle Dynamic programme selected.
GO A15
Wheel spin with Motorcycle Alu programme selected.
St
Wheel spin with Static programme selected.
CCC CCC
Unbalance values greater than 999 grams.
EFFICIENCY OF BALANCING ACCESSORIES
Checking balancing accessories allows the operator to make sure that wear has not
altered the mechanical specifications of flanges, cones, etc. beyond the specified limits.
A perfectly balanced wheel, which has been disassembled and reassembled in a dif-
ferent position, should not show an unbalance value greater than 10 grams.
When a higher unbalance is found, check all the accessories carefully and replace the
components that are not in perfect condition (e.g. showing dents, abnormal wear,
flange unbalance, etc.).
Anyhow it is necessary to bear in mind that, if the cone is used to centre the wheel,
satisfactory balancing results cannot be achieved if the central hole of the wheel is
out-of-round or incorrectly centred; Better results can be achieved by centring the
wheel using the securing holes.
Bear in mind that any re-centring error made when the wheel is mounted on the car
can be removed only removed with an "on-the-vehicle balancing" of the wheel, using
an on-the-vehicle wheel balancer to complement the work of the wheel balancer.
Operator's manual MT 3100 - MT3200
keys until the LED corresponding to the CAL
key twice to confirm the selection. The "CAL" message
o
ther Messages
97
Publicité
